JLT CAI2-FMB-01 Cold Air Intake with Oiled Filter

INTAKE TUBE DESIGN
Using the original JLT CAI as a guide, we molded, sculpted, and perfected everything until we had the best looking, fitting, and performing system you can buy. The new JLT tube is 4 1/4" ID, roto-molded plastic to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!

The MAF and filter are relocated into the fender well for a cooler intake charge and can support 550-600 RWHP. Works with both 80mm and 90mm MAF's, no need to buy more parts when you upgrade to a 90mm MAF.

MOLDED-IN MAF
The best part of this new JLT Cold Air is we kicked the cool factor up a notch and molded a 105mm MAF housing right in the tube. Now you have a kit you can grow into and not have to buy a complete new kit when you reach 550-600 RWHP. Putting a Whipple, Kenne Bell, or Eaton blower swap on your Bullitt? Simply drill out the pre-molded plug on the MAF block located on the bottom of the tube, discreetly out of sight. Install your SCT MAF sensor electronics, add our huge 4.5 X 12” S&B filter and you’ve now changed your JLT Cold Air Intake into a JLT High Boost 12” Intake. Molding the MAF into the tube makes for a much smoother airflow with no couplers, reducers or separate MAF housing and can support 800+RWHP for only the cost of a 4.5x12" filter and hardware, $60.00.

KIT INCLUDES:

• JLT plastic intake tube
• Silicone Coupler
• Silicone reducer
• Apron Plate
• 4x6 S&B air filter
• Silicone MAF spacer
• MAF adapter
• MAF adapter gasket
• HD Clamps & all needed hardware

Will not fit with most strut tower braces.

Vehicle Applications: