Dfuser Motorsports 1001044 Blueprinted Front Wheel Hub

 If you're running your NA or NB Miata hard on the track, you're probably burning through front wheel bearings on a regular basis. And that means you're losing track time or races. ART knows this, so they've put together these blueprinted hubs. They start off as factory hubs, but they're carefully checked and packed with a high temperature grease. They'll cut down your failure rate dramatically.

Sure, they're a bit more expensive. But they'll last a whole lot longer than stock ones, so you'll save money in the long run.

Available either with stock studs or with strong extended ARP units. If you go for the ARP units, you will need to press them into the hubs.

Will not work with ABS. ABS Hubs are special order and sold individually.

Nuts and Cap are not included but are highly recommended.

Recommended installation is to have everything very clean, install and torque to 150 ft-lbs. After a couple of hours of running, re-torque to 150 ft-lbs.  DO NOT use a Toque gun.

Only HUB and standard studs pictured are included.

Reference: (NA01-33-04X) OR HUB404-1

Vehicle Applications:

• 1990-2005 Mazda Miata 1.6L NA6 & 1.8L NA8, NB1, & NB2
  

More Information:

• Install Guide